Use and Care Guide

Lowes.com/masterforge

COOKING WITH GAS

For Natural Gas Connection

Preparing:

1. Turn off gas supply and then remove cap on gas supply side.

2. Recommended: Install a shut-off valve on gas supply side before installing the socket.

3. Socket should be installed by an authorized technician in accordance with the national fuel gas

code (NFPA 54/ANSI223.1).

4. Before inserting plug, turn on gas supply and leak test all connections including the stem of the

shut-off valve and the opening of the socket. For best results, use an ammonia-free soap and

water solution.

Operating Instructions:

1. To connect, push back socket sleeve (Fig. 23).

2. Insert plug and release sleeve (Fig. 24).

3. Push plug until sleeve snaps forward (Fig. 25).

(Gas will ow automatically. Failure to connect

plug properly to socket will inhibit gas ow to

the appliance.)

4. Test connection with ammonia-free soap and water solution.

To disconnect:

1. Pull sleeve back. Pull plug out of socket. (Gas is automatically shut off.)

2. Close shut-off valve and replace dust caps on socket and plug.

Gas Requirements:

The RT2417S grill is set and tested at the factory for the type of gas supply to be used.

Identify the type of gas, either natural gas or LP gas, and make sure the marking on the rating

plate matches the gas supply. The rating plate is located on the inside panel of the door.

Socket

Sleeve

Plug

Fig. 23 Fig. 24

SleeveSocket

Sleeve

Socket

Fig. 25