Use and Care Guide

Lowes.com/masterforge

CARE AND MAINTENANCE

Checking the Flame

Refer to Fig. 29 below (side view of grill). Check the ame after the grill is lit. Make sure you

have a stable, mostly blue ame.

Flame Observation Hole

Fig. 29

Air Shutter Adjustment

The main burner shutters are adjusted at the factory for your convenience. The settings are:

(1) Full open for LP gas.

(2) Half open for NG gas.

If you desire to ne tune your shutter adjustment (or if your ame is more yellow rather than

blue), please follow this procedure.

WARNING: Do not touch burner after adjustments. The burner is hot.

a. Loosen the air shutter. The shutters are located on the end of the gas burners underneath the

control box. See Fig. 30

b. Loosen the air shutter screw.

c. Light the burner to be adjusted.

d. With a protected gloved hand, ne tune the air shutter until a stable, mostly blue ame is observed

through the ame observation hole and slots on each side of the burner box. Acceptable ames

are shown in Fig. 31

e. Tighten the air shutter locking screw enough to hole the shutter in place.

f. Repeat procedure on other burners.

(a)

(b)

(c)

Fig. 30 Air Shutter Fig. 31 Acceptable Flame (only a)

Air Shutter

√