Instructions / Assembly

4
SAFETY FEATURES
WARNINGS AND IMPORTANT SAFEGUARDS
SAVE THESE INSTRUCTIONS
Lid SwitchPrevents grill from overheating.
• If the set temperature is above 500°F (260°C) the controller will regulate the grill temperature
to 500°F (260°C) when the grill lid is opened. Once the lid is closed the grill will return to the set
temperature.
If the set temperature is below 500°F (260°C) the controller will continue to regulate the grill at the
set temperature when the grill lid is opened.
Hopper SwitchesReduces chimney effect when hopper is opened.
1. Hopper Lid Switch: The fan will stop when the hopper lid is opened. The fan will restart when the
hopper lid is closed.
2. Hopper Ash Door Switch: The fan will stop when the hopper ash door is opened. The fan will
restart when the hopper ash door is closed.
This product does not come with charcoal or wood chunks.
• The extension cord must be a grounding-type 3-wire cord.
• Outdoor extension cords must be used with outdoor use products and are marked with suffi x “W” and
with the statement “Suitable for Use with Outdoor Appliances.”
• CAUTION - To reduce the risk of electric shock, keep extension cord connection dry and off the ground.
• Do not let cord hang on or touch hot surfaces.
• Do not place cord on or near a gas or electric burner or in a heated oven.
• To disconnect, turn controller “OFF” then remove plug from outlet.
• Unplug from outlet when not in use and before cleaning. Allow appliance to cool completely before
adding/removing internal components.
• Do not clean this product with a water sprayer or the like.
Grill should only be rolled on smooth surface.
Grill should never be rolled up/down stairs or uneven surface.
Potential damage to grill or harm to user may result from failure to follow warnings.
Never open hopper during use. If it is necessary to refi ll charcoal during use follow the specifi c reload
instructions for this grill and always wear protective gloves.
Never operate the grill with the temperature probe removed. This can cause the grill to overheat and
cause serious personal injury and/or damage to the grill.
Install heat intake and air intake slides after every use.
Remove heat intake and air intake slides before every use.
Never operate the grill with the heat intake and air intake slides installed in the grill. This can damage the
grill.
• Do not use indoors!
• WARNING! Do not use spirit or petrol for lighting or re-lighting! Use only fi relighters complying to EN
1860-3!
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired operation of
the device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.