User manual

Masterclock www.masterclock.com

To open the “Device Settings” window, double click the

CLDNTD12 clock name. The top left item is labeled

“Configurable Options.”

WITHIN THE DROP-DOWN WINDOW:

Click on a menu choice to open the window for that function.

[PROPERTIES] BUTTON

The “Properties” window lists the name, model, firmware and

network configuration of your CLDNTD12 clock. These

configurations may be changed in other windows, but not in this

one. Click [OK] to exit.

[NETWORK CONFIGURATION] BUTTON

The “Network Configuration” window (lower left) lists the

device name and offers a checkbox to “Automatically obtain

network configuration from DHCP/BOOTP” or not. If not, you

may manually fill in the IP address, Netmask, Gateway and DNS.

DEVICE SETTINGS BUTTON

The “Device Settings” window is the same one that appears with

a left double-click of the device on the “Network Discovery”

window (left above, grayed out) and is detailed on page 17.

SET PASSWORD BUTTON

The “Set Password” window permits the user to enter a unique

password for every device to change the factory default

password, “public”.

A password is one to eleven characters and is case-sensitive. For

added password strength, you should use a combination of

alphanumeric and special ASCII characters.

Fill in the old password, “public” then enter the new password

twice. Click [Change Password] to save.

When a password is set for a device, each time you click [OK],

[Apply] or [Apply and Close] for that device you will be asked for

the password. You can select the “Remember this password for

the session” box and you will not be prompted for the

password, until you restart WinDiscovery. Or you can use the

Global Password feature, (page x).

If you enter the wrong password and selected the [Remember

this password for the session] checkbox, you will receive an

error upon clicking [Save] or [Save and Close] to any

configuration changes. You can close the WinDiscovery session

to forget the wrong password(s), however this will require

entering the passwords again for each device.

Alternately, you can remove the incorrect password entry during

a WinDiscovery session by going to the drop-down menu for the

device and selecting the [Forget memorized password] button.