Instructions

ManualsBrandsMasterCool ManualsHeating, Ventilation, and Air Conditioning4000 CFM Slim Profile Window Evaporative Cooler for 1600 sq. ft.

P/N 72469 Page 1

February 2013

Remove

barbed

fitting

PURGE CONVERSION INSTRUCTIONS

FOR MCP44

Description: This document provides instructions for installing a water purge pump onto the

MasterCool MCP44 window evaporative cooler.

CAUTION: Ensure unit is turned fully off and unplugged from electrical outlet.

Turn off and disconnect water source to cooler unit before proceeding.

1. Remove back of cooler by extracting 2 screws

from top and 2 screws from bottom of cooler

back.

2. Disconnect water supply tube from the water

distribution tray.

3. Remove existing hose assembly and replace with

long piece of tubing from kit.

4. Attach bracket to pump with two screws (included) and place strainer basket under pump before

installing purge pump assembly to cooler body in space provided.

Vea la página 3

para el español.

Place

strainer

screen

under pump

then secure

pump

assembly

to cooler

body.

Remove and discard

existing water hose.

Replace with long

hose from kit.

Summary of content (4 pages)

PAGE 1
Vea la página 3 para el español. PURGE CONVERSION INSTRUCTIONS FOR MCP44 Description: This document provides instructions for installing a water purge pump onto the MasterCool MCP44 window evaporative cooler. CAUTION: Ensure unit is turned fully off and unplugged from electrical outlet. Turn off and disconnect water source to cooler unit before proceeding. 1. Remove back of cooler by extracting 2 screws from top and 2 screws from bottom of cooler back. 2.
PAGE 2
5. Attach one end of purge hose (short hose) to the purge pump and the other end to the overflow fitting. Ensure overflow fitting is securely tightened to prevent leaks during operation. 6. Remove receptacle cover on back of fan housing by extracting two screws. Locate the receptacle inside the access panel using needle nose pliers or other means to extract it. Insert the purge pump plug into the receptacle marked with a “P” sticker.
PAGE 3
INSTRUCCIONES PARA CONVERSIÓN DE PURGADO PARA MCP44 Descripción: Este documento proporciona instrucciones para instalar una bomba de purgado de agua en el enfriador de ventana por evaporación MasterCool MCP44. ADVERTENCIA: Asegúrese que la unidad esté completamente apagada y desconectada de la toma eléctrica. Apague y desconecte el suministro de agua hacia la unidad enfriadora antes de proceder. 1.
PAGE 4
MANGUERA DE PURGADO Asegúrese de que la grifería de rebose esté firmemente ajustada para evitar que haya filtraciones durante el funcionamiento. UNIÓN DE DESBORDAMIENTO 6. Retire la cubierta de la toma de la parte posterior de la carcasa del ventilador extrayendo dos tornillos. Ubique la toma dentro del panel de acceso usando pinzas de punta o algún otro medio para extraerla. Introduzca el enchufe de la bomba de purga en la toma marcada con un autoadhesivo con una “P”.