Installation Instructions

a
)
Check your rough opening The
rough opening height should equal the
door slab height plus 2-1/2". The rough
opening width should equal the door
slab width plus 2" for a door without
an astragal; and plus 2-1/2" for a door
with an astragal
(
fig.1
)
.
b
)
Check the opening and both walls
for plumb and square
(
fig.2 & fig.3
)
.
Make the necessary corrections prior to
installing the door unit. If the opening is not plumb the door will not hang correctly.
Install one door hanger flush with the top of each hinge.
Use the supplied screws included with the door hanger
(
fig.4
)
. This should be repeated for all six hinges.
INTERIOR DOUBLE DOOR SYSTEM
INSTALLATION INSTRUCTIONS
REQUIRED TOOLS
WARNING
Door Units Are Heavy! Use an adequate number of people to set the unit and prevent injuries or damage to the door.
1
)
Check Rough Opening
2
)
Install Hanger
3
)
Opposite Hangers 4
)
Bend Hangers
g. 3
Place six additional hangers directly in
line with the hinge side hangers that
were just installed in step 2
(
fig.5
)
.
Using a pliers, bend the six clips on the non-hinge side
(applied in step 3) so that they are parallel with the
jambs
(
fig.6
)
.
g. 5
g. 4
g. 6
g. 1
g. 2
• Wood Chisel • Utility Knife Punch • Marker • 2-1/2" Finishing Nail Qty: • 2-1/2" Wood Screws Qty: 6
• 8d Finishing Nails • Wood Shims (1pkg.) • Door Hangers