Use And Care Manual

Page 11
OPERATION
OPERATION INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
Intended Use
The machine is intended for cutting, roughing
and brushing metal and stone materials
without using water. For cutting metal, a special
protection guard for cutting (accessory) must be
used.
1. INSTALLING THE AUXILIARY HANDLE
(SEE FIG. A1, A2)
You have the option of two working positions to
provide the safest and most comfortable control
of your angle grinder. The handle is screwed
clockwise into either hole on the sides of the gear
case.
Vibration-dampening Auxiliary Handle
The vibration-dampening auxiliary handle
reduces the vibrations, making operation more
comfortable and secure. Your tool is equipped
with an auxiliary handle that can be used for
storage of the spanner. (See Fig. A2)
Fig. A1
Fig. A2
2. INSTALLING AND ADJUSTING THE DISC
GUARD
Make sure the grinder is unplugged before
making any adjustments.
For work with grinding discs, the disc guard must
be mounted.
The projection on the disc guard ensures that
only a guard that ts this angle grinder can be
mounted. Raise the guard clamping lever (See
Fig. B1).
To install the guard align the guard projection
with the matching groove on the spindle housing
(See Fig. B1). Push the guard down as far as it
will go.
Rotate the guard to a working position (See Fig.
B2 example).
NOTE: working position is with the closed side
of the guard toward the operator and open
side pointing directly away from the operator to
provide maximum protection against sparks and
ying debris.
Close the clamping lever to tighten (See Fig. B3
example).