How to Guide

Table Of Contents

TRANSMITTER SETTING

This DC motor is equipped with self-learning frequency function transmitter. Read all the steps

BEFORE proceeding. Each step must be followed exactly in order to program the transmitter.

To use factory pre-programmed setting – Skip the below programming steps. Insert battery

into transmitter, turn on the power supply to fan and it is ready to use.

FIRST ONE USE INSTRUCTION

1) Dial up to position“O”, it is on/off only for the lighting,

and it is the brightest of the light.

2) Dial down to position“D”, the brightness of the light can

be control low or high.

SECOND ONE USE INSTRUCTION

1) If you have more than 1 unit of this fan model in close

proximity, it is equipped self-learning, please don’t press

any key when self-learning.

2) To set the second one down to the position of "1" (set to

"0" position on one product when used directly).

3) Turn on the power of the light fan.

4) Within 30 sec after the “Beep”, press and hold the

LEARN button for 3 sec. Once the receiver has detected and

learned the frequency, the receiver will “Beep” twice,

meanwhile the light will bright out twice.

Programming/self-learning process is completed and fan is

ready to use.

ATTENTION

1) If the fan is not responding to the transmitter. Turn off the power supply to fan for 30

sec and then restore power & reset the transmitter.

2) If long time not to use the transmitter, please take the battery out.

LEARN

O 0

D 1

TRANSMITTER FUNCTION