How to Guide

STEP 2
1) Remove the Clevis Pin (8), Nut (9), Spring Washers (11), Flat Washers(12) & Bolt (10) on
Coupling (14).
2) Loosen the Screw (1) from Hanger Ball (3), remove the Hanger Ball (3) and Lock Pin (2).
3) Route the wires and safety wire from the motor through the
Downrod
(7).
4) Install the
Downrod
(7) to Coupling (14) and secure with Bolt (10), Flat Washer (12), Spring
Washer (11), Nut (9) & Clevis pin (8).
5) Tighten the 2 Set Screws (13) on the Coupling (14) to serve as a clamping force on the
Downrod
(7) to prevent fan shaking during operation.
6) Route the Coupling cover (6), Canopy Ring (5), Canopy (4) and Hanger Ball (3) through the
Downrod
(7) in turn, and then install the Lock pin (2) through the hole on the
Downrod
(7). Slip the hanger
ball (3) upward to lock Pin (2), and fix it by Screw (1), then slip down the Coupling Cover (6) in
correct position.
7) Remove the stopper(x3) on the top of fan motor.
(10)
(13)
(8)
(11)
(9)
(12)
(7)
(14)
(3)
(7)
(1)
(2)
INSTALLATION INSTRUCTION
5