- Matrix Network Router User Manual
2 lms057_ap_01
Local Link Address Support
12
XXXX X X
MDB1000 Installation Tool Support
13
XX
OFDM: Multiple Modulation Schemes from 1.5
to 13.5 Mbps raw rate
14
X
Outdoor Enclosure
15
XX
Power over Ethernet
16
XX
Radio Link Antenna Pointing Tool
17
XXX
RSS (Received Signal Strength) LED
18
XXXX
Secure Authentication
19
XX
Serial Port
20
X
Setup Menu
21
XXX
Simultaneous voice calls - two
22
XXXX X X
Simultaneous voice calls - more than two
22
X XXX
Temperature Rating (Operational) [C]
10 to
40
0 to
40
0 to
40
-10 to
50
-40 to
50
23
-40 to
50
23
TKIP Data Encryption
24
XX
1. Adaptive Modulation selects the optimal transmit modulation scheme for the link to the CCU.
Each EUM selects its own optimal scheme. See “Adaptive Modulation” in LMS8000-LMS4000
Radio Networking Concepts for details.
2. Autoconfiguration allows the operator to configure EUM parameters remotely via RADIUS
message attributes. CCU/NCL software version 6.0 or 20.0 or higher is required to support this.
See “Configuring a RADIUS Server” in LMS8000-LMS4000 Managing the Network for details.
3. Automatic Frequency Discovery allows the EUM to determine which frequency and CCU to
connect to based on the best available signal without operator intervention or configuration. CCU/
NCL software version 5.0 or 20.0 or higher is required to support this. See “Automatic Frequency
Discovery” in LMS8000-LMS4000 Data Networking Concepts for details.
4. These modems are compatible with the CCU8000. The EUM3005 and EUM3006 must have at
least version 11.3 software to be compatible, otherwise no communication is possible. The
CCU8000 will automatically use CCK modulation with the EUM3005 and EUM3006.
5. A DHCP client allows a unit to obtain its IP parameters from a central server, rather than having
them statically configured by the operator. See “DHCP Client” in LMS8000-LMS4000 Data
Networking Concepts and “Configuring a DHCP Server” in LMS8000-LMS4000 Managing the
Network for details.
6. This Windows only graphical user interface utility can be used by an installer or an end user to
optimally align the EUM antenna.
7. This Windows only graphical user interface utility can be used to configure EUM parameters. See
LMS8000-LMS4000 EUM Configuration Utility Guide for details.
Feature
EUM
3000
EUM
3003
EUM
3004
EUM
3005
EUM
3006
EUM
8000