Marine Battery User Manual

Model No Wire AWG Inline Fuse

ST1000-112 / 212 # 2 150 A

ST1000-124 / 224 # 4 80 A

ST1000-148 / 248 # 6 40 A

ST1500-112 / 212 # 2 200 A

ST1500-124 / 224 # 4 100 A

ST1500-148 / 248 # 6 50 A

ST2000-112 / 212 # 2/0 250 A

ST2000-124 / 224 # 1/0 125 A

ST2000-148 / 248 # 2 70A

ST2500-112 / 212 # 4/0 400 A

ST2500-124 / 224 # 2/0 200 A

ST2500-148 / 248 # 1/0 100 A

3-3-1. Connect the cables to the power input terminals on the front panel of

the inverter. The red terminal is positive (+) and black terminal is

negative (-). Insert the cables into the terminals and tighten screw to

clamp the wires securely.

WARNING!

Make sure all the DC connections are tight (torque

to 9 – 10 ft-lbs, 11.7 – 13 Nm). Loose connections

could result overheat in a potential hazard.

WARNING!

The installation of a fuse must be on positive cable.

Failure to place a fuse on “+” cables running between

the inverter and battery may cause damage to the

inverter and will void warranty.

Also, only use high quality copper wire and keep the cable length short which

is a maximum of 3 - 6 feet.