Specifications

40
9.3 DECK REMOVAL
1) Remove the motor cover as outlined in Section 9.1.
2) Remove the four deck screws using a 5 mm Allen wrench (Figure A).
3) Remove the deck from the running belt (Figures B & C). NOTe: Be careful not to pinch fingers during removal / installation of the deck.
4) Reverse Steps 1-3 to install a new deck. NOTe: New deck surfaces must ALWAYS be matched to a new running belt, but the deck is
waxed on both sides so the opposite side surface may be usable.
5) Test the treadmill for function as outlined in Section 9.21.
FIGURE A
FIGURE B FIGURE C
CHAPTER 9: PART REPLACEMENT GUIDE