User`s manual

4Ch H.264 hardware codec
- Network DVR
25
MOTION SETUP
MOTION SETUP : You can change values by mouse wheel and left/right button of a mouse.
- SENSITIYITY : Adjusting sensitivity of a movement. You can adjust level 1 ~ level 5. [DEFAULT : 1]
- DURATION : Whenever motion is detected and it is set at Motion Recording mode,
DVR records for a certain time being from the point of time when motion is detected.
(1 sec.~99 sec.) [DEFAULT : 1 sec.]
- DETECT CELL NUM. : Select the minimum of CELL for MOTION EVENT to be activated.
- ALL-DEFAULT: Default setup for all channels
MOTION MASK SETUP : Set motion detection area.
- CELL : Move to the cell and then decide to make it activated or deactivated by clicking it.
When the cell is activated, motion is detected. Motion is not detected on deactivated cells.
Whenever you click a cell, it changes between activated and deactivated.
BOLCK SETUP: First, you decide ¡Activated¡ or ¡Deactivated¡ by clicking a cell.
Then, if the initial cell is ¡Activated¡, the blocks dragged by a mouse are also activated.
If the initial cell you select is deactivated, the blocks dragged are also deactivated.
CHANNEL CH1
SENSITIYITY 5
DURATION 05
ALL-DEFAULT ESC
Blocked Area
(non-motion detection area)
Non-Blocked Area
(motion detection area)
4) MOTION SETUP
CHAP. 5 Set up
Created with novaPDF Printer (www.novaPDF.com). Please register to remove this message.