User`s manual

4Ch H.264 hardware codec
- Network DVR
26
See the switching time interval for SEQ or PIP function.
(1 sec. ~99 sec. ）
SEQUENCE SCREEN :Set the sequencing switch time
interval in live full screen.
PIP SCREEN : Set the sequencing switch time interval
of PIP window.
EVENT UPDATE : Set the minimum time interval of event
to be listed on EVENT LIST.
If EVENT UPDATE time is set at 5 sec, only following event happened 5 sec
or more than 5 sec later previous event shall be listed on EVENT LIST.
INTERVAL SETUP
SEQUENCE SCREEN
PIP SCREEN
EVENT UPDATE
01 SEC
01 SEC
600 SEC
DEFAULT ESC
5) INTERVAL SETUP
6) ALRAM SETUP
ALRAM SETUP
CHANNEL
INPUT
DURATION
ALL-DEFAULT
CH1
DISABLE
01 SEC
DEFAULT ESC
INPUT : Select NORMAL OPEN, NORMAL CLOSE,
or DISABLE.
DISABLE represents not to use alarm sensor
connected to DVR.
DURATION : Set the duration of alarm when an ALARM
is activated. (0 sec. ~ 300 sec.)
Set type of alarm sensors connected to DVR unit.
N.O represents Normal Open type and N.C Normal
Close type.
7) PASSWORD SETUP
PASSWORD SETUP
USER ID
USER PW
NEW PW
CONFIRM
ADMIN
--------
--------
--------
1 2 3 4 5 6 7 8 9
ENTER ESC
To change password, you need to click ¡USER
PW¡ first to activate the menu.
You must input current password and then
input new password.
And input again new password to confirm.
Set user ID and Password.
You can make up to 8 digit number combination
for a password by clicking number ¡1¡ ~ ¡9¡ on
password setup menu.
※ Changing the user Password in the first operation is recommended.
Number selection for password
CHAP. 5 Set up
Created with novaPDF Printer (www.novaPDF.com). Please register to remove this message.