User`s manual

4Ch H.264 hardware codec
- Network DVR
28
1) CHANNEL : Select channel
2) MODEL : Select camera model (protocol type) per each channel
3) PTZ ID : Select PTZ ID (per each channel)
4) BAUDRATE : Select data transmission speed
5) CMD DELAY : Select command delay time
CHAP. 5 Set up
5) SPOT SETUP
SPOT SETUP
SWITCH INTERVAL 03 SEC
ALARM POP UP ON
MOTION POP UP ON
EVENT POP UP DURATION 05 SEC
DEFAULT ESC
(1) SWITCHING INTERVAL
Channel switching time (01 sec. ~ 99 sec.)
(2) ALARM POP-UP
When ALARM is detected, the image of channel
connected with Alarm sensor pops up.
Set ALARM detection pop-up (ON/OFF)
(3) MOTION POP-UP
Set MOTION detection pop-up (ON/OFF)
If events (MOTION or ALARM) happen on several channel at the same time, channel No. 1
has the first priority to pop up. For example, if events happen on channel No. 1, channel
No. 2, and channel No. 4 at the same time, channel No. 1 pops up. If the motion
disappears on channel No. 1, then channel No. 2 pops up for the duration that you set.
However, even though motion happens on channel No. 1 again within the duration,
channel No. 2 still displays. If motion on channel No.1 keeps on going even after the
duration, channel No. 1 pops up again.
※ EVENT POP-UP DURATION
Set EVENT POP-UP DURATION
3) MOUSE SETUP
If you increase sensitivity, mouse cursor
moves fast.
MOUSE SETUP
SENSITIVITY 3
DEFAULT ESC
AUDIO SETUP
CHANNEL OFF
INPUT VOLUME 00
OUTPUT VOLUME 00
DEFAULT ESC
4) AUDIO SETUP
If you select a channel, the audio of the selected
channel is recorded.
(1) CHANNEL : By selecting a channel, you can set
audio recording ON/OFF.
(2) INPUT VOLUME : Volume setup for microphone
(3) OUTPUT VOLUME : Volume setup for speaker
Created with novaPDF Printer (www.novaPDF.com). Please register to remove this message.