User`s manual

4Ch H.264 hardware codec

- Network DVR

CHAP. 6 Network Setup

6-1. DVR Network Configuration

Please call your provider to identify what type of service they are providing you. You will need to

know following :

Upload speed ? For your own knowledge for expected frame rates.

Download speed ? For your own knowledge for expected frame rates.

Addressing ? For determining what scenario you should follow.

Router ON Site or Just a Modem ? For determining what scenario you should follow.

※NOTE : If your provider is using PPPoE ( usually DSL providers ), you MUST hlledave a router

installed on site and follow CASE C For DVR setup and access.

※Please verify Internet access after installing any new equipment (routers, switches, modems etc)

PC¡s TCP/IP Setting

Before configuring the DVR, please fill out the information below if applicable;

Choose any PC on your network and determine its TCP/IP settings;

IP Address : (ex.192.168.1.5)

Subnet Mask : (ex. 255.255.255.0)

Default Gateway : (ex.192.168.1.1)

CHAP. 6 Network Setup

Next pages are several network scenarios. Please identify which scenario your current

network falls within and follow the instructions for configuring and accessing your DVR via

TCP/IP.

Created with novaPDF Printer (www.novaPDF.com). Please register to remove this message.