User manual

41
Ernitec EDNS V1000 series – user manual
www.ernitec.com
V 2.2.082012
3.6.6 Event Full Screen
This function allows the DVR to display the alarm channel in full
screen size when an alarm is triggered. Select <None> to disable
this function; select <Main> to display the alarm channel on Main
Monitor when an alarm is triggered; select <Call> to display the
alarm channel on Call Monitor; and select <Both> to display the
alarm channel on both Main Monitor and Call Monitor.
3.6.7 Event Duration
This item determines the duration of the buzzer and Alarm Out
relay function after an alarm is triggered. The available event
duration range is from 5 second to 999 seconds.
3.6.8 Per Channel Config
This menu is used to configure the <Video Loss Detect>,
<Motion Detect>, <Alarm In> and <Alarm Out> settings for each
channel. The menu is displayed as below.
Per Channel Config
Channel Select
Video Loss Detect
Motion Detect
Detection Config
Alarm In
Alarm Out
CH01
Off
Off
ENTER
OFF
OFF
3.6.8.1 Channel Select
The item is used to select a desired channel for setting the
parameters. Move the cursor to <Channel Select> and press
ENTER, then select a channel using UP / DOWN keys. Press
ENTER again to confirm the selection.
3.6.8.2 Video Loss Detect
This item allows users to enable or disable Video Loss as an
alarm event. Select <On> to enable Video Loss alarm events, or
<Off> to disable.