User manual

Ernitec EDNS V1000 series – user manual

www.ernitec.com

V 2.2.082012

Sensitivity

This item is used to set the sensitivity of detection grids for the

camera. A greater value indicates more sensitive motion

detection. A motion alarm will be triggered once the amount of

motion detected exceeds the Threshold value.

Move the cursor to <Sensitivity> and press ENTER, and then

use UP/ DOWN keys to adjust the value. The value is increased

by 4% increment.

Block Threshold

<Block Threshold> indicates the motion alarm triggered level;

select from <1> to <16>. Selecting <1> means the DVR will

trigger the alarm when one grid is detected; and selecting <16>

means the DVR will trigger the alarm when 16 grids are detected.

Move the cursor to <Block Threshold> and press ENTER, and

then use UP / DOWN keys to adjust the value.

3.6.8.5 Alarm In

This item allows users to enable/ disable alarm input detection.

According to users’ application, select <N/O> (Normal Open) or

<N/C> (Normal Close) to enable the alarm input detection, or

select <OFF> to disable the detection.

If <N/C> is selected without installing any device, an alarm will be

triggered and the Event Icon will always display on the monitor

until the selection is changed to <N/O> or <OFF>, or when a

device is installed.