User manual

52
Ernitec EDNS V1000 series – user manual
www.ernitec.com
V 2.2.082012
4.2 Sequence
This section introduces the way to view sequence mode with
both Main Monitor and Call Monitor, if connected. Sequence
function can avoid manual backtracking and provides more
flexibility while monitoring surveillance.
4.2.1 Sequence with Main Monitor
Automatic sequence function can be observed in any view mode.
Select certain view format and press SEQ to toggle the
automatic sequence; press ESC to stop sequencing. The figure
below displays the 4-camera and 9-camera sequencing view
modes.
4-camera:
9-camera:
(for 16CH models only)
4.2.2 Sequence with Call Monitor
Users are allowed to use the DVR front panel to control a call
monitor display without having to access the Main menu. Two
viewing modes can be displayed on call monitor: Sequence
display and Single camera display. To program the call monitor
sequence, see OSD Setup Manual, section Sequence Setup.
Follow the steps to control the call monitor.
 Press the CALL key on the front panel to enter Call Monitor
Control mode. The “Call Mode” icon will be shown in the
status bar.
Press 1-16 Key To Select Channel
Press SEQ To Enable Sequence