User manual

76
Ernitec EDNS V1000 series – user manual
www.ernitec.com
V 2.2.082012
operation can be accessed. To choose desired display mode and
to operate dome camera control, refer to the following sections.
5.3.1.1 Select Display Mode
Choose the number of windows to be displayed on the main
window. Click one of the display buttons in MODE section.
Available selections are 4, 9 and 16 camera displays. To view
certain window in full screen, either double-click on the wanted
window, or click on the corresponding CAMERA button.
5.3.1.2 Operate Cameras with Dome Control
The remote monitoring software allows users to control and
configure a dome camera remotely.
Click on any CAMERA button displayed with a dome icon to view
the camera in full screen. The Dome Control Panel will be
displayed on the main window. The items on the dome control
panel are described as follows.
Set Preset (•)
Set Preset is used to set up preset positions. The remote
monitoring software allows its user to set up to 255 preset
positions according to the allowance of the supported dome
cameras.
Use Direction buttons to move dome camera to an appropriate
position, and then click the button and choose wanted number
from the pull-down list. The preset position is named as the
selected number.
Go Preset (•)
Go Preset is used to call the camera preset point, which was set
up with the set preset point function. Click and choose a number
to call the preset point for viewing.
Auto Focus (A.F.)
Click on it and the focus of the camera will be automatically
adjusted to show a clearer image.