Getting Started Power Source Choosing a Working Voltage The stern can nn either on AC 118V or AC 230V Slide the AC voltage select switch on both of the two owe supply units to the compact position which corresponds with The will outlet supply voltage. Wrong AC Cottage input will harm fhe power supply ang course serious damage 1o the Disk Say. Huger © Power Source This Disk Ara I supplied with on AC power cord equipped witty a wire grounding type plug.
Getting Started Hard Disk Drives Pr-Sefting 1. HOD SCS! Terminator : $61 ¥ Disable SCSI Terminator important | You must set disable SCS! terminator fo all of these drives Sven it is on the end the device channel bus. 2. Terminator Po wet : set “Term, Power from SCS Bus”. 3. Motor Star option © set " Enable mayor sin 4. Setting the SCSI ID: P re-seling is not necessary.
Getting Started About HDD's Auto SCS! 1D# Hefting Corpsman optional SCSI Usage Plug: Pins Assignment Pin Signet 119 7 531 noon pan 5 A orthogonal 7 A3 3 LED Cathode 12108 You must check the HDD's installation guide before you install the dives, if your dives have nat this rear optional usage plug of the pir assignment Is different OM 1he above common usage plug, then you must set the HDD's SCHEMED# manually us below © Tray 1: 1D#0 Tray 2: 0%) yr Tray 3 1 1D#2 —— Tray 45 1043 0 Tia B 1 ID#0 _— Tray 61 1D#1 E
Getting Started Step 2 : Unlock the HOD tray by muting the Key-lock soothe connect position. Step 31 Gently Pull out the HOD fray. VT ll.
Gelding Started Step 4 Insert HOD into the ray Step 6: Screw in the hard dive: { Usa the cored size, type and this ad § Step 6 : Cabling, Connect the Data cable , SCSI cable & Power cable.