Specifications

CAUTION!
Check that connections of all equipment and the antenna are proper before connecting the
receiver to the mains.
> Insert the mains plugs of the connected equipment in the mains socket and switch it on.
> Switch on the AV channel of the TV set. If the TV set recognizes the switching voltage
emitted by the receiver, it will switch automatically to the AV mode (with Scart).
> If you want to operate your receiver with 12V, insert the 12V cable into the “DC
12V IN” socket of the receiver and connect it to your power source.
CAUTION!
For using vehicles with 24 volt on-board voltage (eg, trucks), you have to use a 24V/12V
DC/DC converter. If not, the receiver can suffer damages. Your warranty will be lost,
if ignored.
The receiver is supplied with preset TV channels and can be used directly. If you want to
check if new channels are available, initiate a scan for broadcasting stations.
To get into standby mode, press the red key at top left of the remote control. The current
time will be displayed. The device consumes approx. 2W only. Currently, this is a very low
value of power consumption.
Energy saving
This receiver features an On/Off switch. Please turn off at the switch located on the front
of the receiver when not in use. This will reduce any unnecessary drain on your vehicle
battery.
External 3A fuse
Features an easy to access integral rear mounted blade fuse on rear of receiver box for
electrical protection.
Receiver
Page 14
MXL020HD INSTRUCTIONS REVISION.indd 14 15/05/2013 14:12