Specifications
Instructions for the presetting “motor antenna” (antenna with rotating motor)
> LNB type: Set the corresponding LNB frequency for the selected satellite. The
default setting is universal.
> Motor type: Setting of the motor type.
> Local longitude: Only for option “USALS” in the menu item motor type.
> Local latidue: Only for option “USALS” in the menu item motor type.
> Delete all: You can delete all satellite positions previously saved. Not available for
option “USALS” in the menu item motor type.
> Motor setting: Access to the DiSEqC1.2 control centre. Here, individual satellite
positions can be saved.
> Limit setup: Definition of the rotation radius.
Single Satellite Search
In this submenu, you can scan a complete enabled satellite for (new) channels.
> Satellite: Selection of the satellite to be scanned.
> FTA only: FTA = free-to-air channels.
> Option Yes = only free-to-air channels are scanned.
> Option No = encrypted channels are also scanned.
> Scan Channel: Dene if you wish to scan only TV channels, only radio channels or both.
> Network Search: Intelligent scan. Only available if Preset scan has been selected in the
next menu item.
> Scan mode:
Option Automatic scan: The complete satellite will be scanned. No data required. Option
Default setting for scans: Only transponders already created will be scanned.
> Search:
The scan will be started by pressing the OK key. The found channels are added at the end
of the general satellite list.
Multi Satellite Search
Here, you can scan all satellites enabled in the submenu item “Satellite list” at once.
The setting of the scan filters is described in the previous submenu item.
Page 24
MXL020HD INSTRUCTIONS REVISION.indd 24 15/05/2013 14:12