Specifications

Page 7
The receiver is connected with your satellite antenna with a coaxial cable.
If necessary, you have to prepare a coaxial cable before connecting the receiver.
CAUTION!
Connect the receiver to the mains supply only after you have connected it to all equipment
and the antenna properly. Otherwise, the receiver can suffer damages and there is a risk of
electric shock that can be a threat to life or physical condition.
DANGER!
Camping or trailer operating: The receiver can also be connected to 12 Volt (11-15 Volt,
e. g. solar collector, motor vehicle). To do this, use the 12 Volt cable.
CAUTION!
For using vehicles with 24 volt on-board voltage (eg, trucks), you have to use a 24V /12V DC
/ DC converter. If not, the receiver can suffer damages. Your warranty will be lost,
if ignored.
(See the installation diagram on the next page) For the installation of the F connectors on
the coaxial cable you need a knife (ideally a wire stripper) and side cutting pliers.
> Cut 8mm of the coaxial cable at each end up to the inner core.
> Carefully cut 10mm of the outer insulation so that the wire netting is exposed.
> Turn the wire netting backwards and wind it over the outer insulation in such a
manner that it does not touch the inner core.
> Remove the inner insulation up to 2mm from the wire netting.
> Rotate the F connector onto the turned-back wire netting till the connector
touches the inner insulation.
Connecting receiver
LNB cable installation
MXL020HD INSTRUCTIONS REVISION.indd 7 15/05/2013 14:12