Installation Guide

SERIAL NUMBER INFORMATION
The serial number of all self-contained refrigerators and freezers is located inside the
unit on the left hand side near the top on the wall. Always have the serial number of
your unit available when calling for parts or service. This manual covers standard units
only. If you have a custom unit, consult the customer service department at the number
listed on the last page.
RECEIVING AND INSPECTING THE
EQUIPMENT
Even though most equipment is shipped in protective packaging, care should be taken
during unloading so the equipment is not damaged while being moved into the build-
ing.
1. Visually inspect the exterior of the package and skid or container. Any damage
should be noted and reported to the delivering carrier immediately.
2. If damaged, open and inspect the contents with the carrier.
3. In the event that the exterior is not damaged, yet upon opening there is con-
cealed damage to the equipment, notify the carrier. Notification should be made
verbally as well as in written form.
4. Request an inspection by the shipping company of the damaged equipment. This
should be done within 10 days from receipt of the equipment.
5. Be certain to check the compressor compartment housing and visually inspect the
refrigeration package. Be sure lines are secure and base is still intact.
6. Freight carriers can supply the necessary damage forms upon request.
7. Retain all crating material until an inspection has been made or waived.
SAVE THESE INSTRUCTIONS
maxxx cold manual:Layout 1 5/16/11 11:11 AM Page 4