Use and Care Manual

MAINTENANCE

ing water to back up and overflow the drain pans.

Open the top shroud

Loosen the screws on the bottom of top shroud, then swing top shroud up 180° until it

rest on top of the cabinet.

Door Replacement and Adjustment

1. Open the top shroud and swing it up until it rests

on top of the unit.

2. Open the door to about 100°-110° until the door

remain open.

3. l oosen and remove the top screw of the self-clos-

ing cartridge and the three hinge screws, then slide

the door up and out.

4. Prepare new door. Use a wrench to rotate the

square head of the cartridge shaft approximately

1200 in the closing direction of the door. The hinge is

now preloaded and ready to be secured to the top hinge

5. Hold the door at about 100° from the closed position, insert the top hinge over the

square shaft of the cartridge so that the hinge is facing the cabinet. Insert the mount-

ing screw and fasten securely.

6. Still holding the the entire door/hinge assembly at about100°, slide it over the bot-

tom hinge pin, make sure all the alignment then fasten the upper hinge securely

7. Allow the door to freely swing, make sure it swings closed by itself with no restriction

8. Plug the unit in and make sure the interior light turns off and actives the evap fan

when the door closes

9. If not, adjust the door height by adding the plastic spacer/washer provided to the

bottom hinge pin

Remove the bottom shroud (apply to bottom-mounted only) Loosen

and remove the top screws, slide the shroud up and out

Maxxx Cold Reach-ins Manual 2012VerA:Layout 1 6/7/2012 10:47 AM Page 12