Use and Care Guide

11/07/2017 PK

• The PC board activates the water drain pump for 20 seconds, pumping out

most of the water contained in the water reservoir.

• The water can be pumped out up a rise of 1.5m (59”) or

over a horizontal length of 1.5m (59”).

• If water level switch 2 closes, transmitting a low-voltage current to the PC board, the PC board

activates the buzzer alarm, informing you that the drain pump, water level switch or drain tube may

be malfunctioning.

Drain System Schematic Diagram

NOTE:

The outlet of the drain hose

must be raised higher than

the water surface to prevent

the drained water from

flowing back into the water

reservoir.

WARNING!

If alarm buzzer sounds, turn

off the ice maker and the

water supply, remove all ice

from storage bin, and wipe

up any water that may have

overflowed. Check if there is

any water in water trough at

back of unit; if no water,

drainage pump may not be

receiving the proper amount

of power. Check power

source. If the problem can be

corrected, turn on the unit

again. Also check that none

of the water lines are kinked.

If the problem remains,

contact Customer Service.

Water Level Switch 1

Water Level Switch 2

PC Board