Use and Care Guide

11/07/2017 PK
MAJOR FUNCTIONS
1. The operating procedure is completely automatic.
2. When the ice storage bin is full of ice cubes, the ice maker stops making ice automatically. It starts making ice
again after ice cubes are removed.
3. The different colors of the LED display indicate various work modes.
4. A sensitive probe and accurate timer enhance the performance of the ice maker.
5. A compressor protection system is built in.
TROUBLE SHOOTING
Problem
Possible Cause
Probable Correction
The ice maker doesn’t
operate.
The ice maker is unplugged.
Plug the ice maker in.
The fuse is blown.
Replace fuse. If it happens again, call for service to check
for a short circuit in the unit.
The ice maker power button is set at OFF.
Switch the ice maker power button to ON.
The ice storage bin is full of ice.
Remove some ice cubes. Be sure the ice-
full probe is free
of ice.
The water doesn't feed
in after the ice maker
starts.
The water supply tap is turned off. Turn on the water supply tap.
The water supply pipe is not properly connected. Reconnect the water supply pipe.
Ice maker makes ice,
but bin does not fill up
with ice.
The condenser may be dirty. Clean the condenser.
The air flow to the ice maker may be obstructed.
Check the installation.
The ambient temperature and water temperature
are high, or unit is near some heat source.
Check the installation.
Water is leaking out of
the unit.
Some water falls to the floor when you open the
door to remove ice from storage bin.
Normal condensation on the door or some water
together with ice. Take care when you take out ice.
Water supply connection is leaking.
Tighten fitting. See Connecting the water line.
Drain pipe higher than drain outlet.
(Applies to
MIM50V/50/50-O only. MIM50P/50P-O has drain pump)
Lower drain pipe.
Cubes are partially
formed or are white on
the bottom.
Not enough water in the water trough.
Check if the water supply pressure is below 15 psi (103
kPa).
Check water supply or filter may be restricted.
Check for a water leak at the water trough.
Noise during operation
The feet are not leveled and locked.
Level and lock the feet.
See Leveling the Ice Maker.
Certain sounds are normal. See Normal Sounds.
The ice maker stops
suddenly while making
ice.
The electricity is off.
Reconnect the power supply line.
The room temperature is out of the stated range.
Cut off the electricity and leave the ice maker
disconnected until the temperature returns to within the
stated range.
The ice storage bin is full of ice.
Remove some ice cubes; make sure the ice-full probe is
free of ice.
The body of the ice
maker is electrified
The ground line isn’t in the socket. Use a socket meeting the grounding requirements.
Scaling occurs
frequently inside the
ice maker.
The hardness level of the water is too high.
Install a water-softening device in front of the water
inlet.
Water leaks from the
ice storage bin.
The drain hole below the ice storage bin is blocked.
Remove the ice storage bin and clean the drain hole.
The drain hose is kinked or improperly placed
higher than the floor of the ice storage bin.
Check the drain hose to be sure water can be drained
out unhindered.
Buzzer alarm.
(Applies to MIM50P and
MIM50P-O only)
Problem in pumping out water.
Check for correct operation of drain water pump, water
level switch and drain tube.