Manualshelf

Use and Care Guide

ManualsBrandsMaxx Ice ManualsAppliances50 lb. Freestanding Icemaker with Drain Pump in Stainless Steel
12345678910
11/07/2017 PK
7
Reversing The Door Swing For MIM50-O and MIM50V
Tools needed: Flathead screwdriver, Phillips screwdriver
NOTE: Before you begin, unplug the ice maker or disconnect power.
To Remove Door From Hinges
1. Remove the top hinge cover.
2. Using a Phillips screwdriver, remove the screws, remove the top hinge mat and top hinge. Keep the parts
together and set them aside. (The MIM50V has a black hinge and no cover or mat, but is removed same
way as MIM50-O top hinge.)
3. Lift the door off of the bottom hinge and set the door aside.
To Replace Door On Hinges
1.
Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the door hinges, top and
bottom. Set aside.
2.
Remove the front louver. Set aside.
3.
Remove the bottom hinge and place it on the opposite side at the bottom of the door. (The MIM50V bottom
hinge removed and installed same way as MIM50-O bottom hinge.)
4.
Position the door on the bottom hinge.
5.
Align the door on the bottom hinge and replace the top hinge and top hinge mat.
6.
Replace top hinge cover.
7.
Push the plug buttons into the original screw holes.
See Figure below:
Top hinge cover
Cabinet
Top hinge mat
Top hinge
Top hinge
Door
Bottom hinge
Bottom hinge
MIM50V black top hinge
no cover or mat.