Instructions / Assembly

PIR LED Shop Light Instruction Sheet

MSL-404600SC

www.maxximastyle.com

5. Install the LED lamp with chains, one end at a time on to each screw eye hook. Crimp

screw eye hook if needed.

6. Plug the power supply cord into the electrical outlet.

Crimp S-hooks

with pliers.

CHAIN INSTALLATION (RECOMMENDED):

1. Mounting surface must be capable of supporting the fixture. For plaster board ceiling, #8

screw eye hooks with plastic anchors are included or expansion bolts may be used (not

included). If installed onto a plaster board surface, we recommend minimum 3/8” thick.

NOTE: You are responsible for secure installation.

2. Install the 2 plastic anchors 47 1/4" apart, then screw the eye hook into each anchor.

3. Install one “S” hook into each end of the chain, then crimp the “S” hook end which is

attached to the chain with pliers.(Leave one side open from the “S” hook) Repeat step for

the second chain provided.

4. Install the “S” hook from one end of the chain into the end cap of the LED lamp, then

crimp the hooks end with pliers. Repeat same step for the opposite side.

3. Lift the fixture and line up the four mounting slots on the bottom to the screws. Slide it

towards the side with the power cord to secure it into place (In the case shown in Figure 3,

slide to the right since the power cord is on the right side).

NOTE: Secure the power cord firmly away from the fixture such that the fixture is securely

held in place and anchored to the screws. Please use discretion to properly place the

power cord away from traffic so that the fixture may not slide out of place and fall due to

accidental contact.

FLUSH MOUNT INSTALLATION:

1. Mounting surface must be capable of supporting the fixture. For plaster board ceiling,

#8 screws with plastic anchors are included. If installed onto a plaster board surface, we

recommend minimum 3/8” thick.

NOTE: You are responsible for secure installation.

2. Install the 4 plastic anchors 46.5" apart across the long side and 3.19" apart across the

short side as seen in the figures below. Insert the screw into each anchor and tighten it.

The space between the ceiling and the head of the screw should be at least 0.33".

4. Plug the power supply cord into the electrical outlet.

LINKING MULTIPLE SHOPLIGHTS:

Connect to

electrical outlet.

Link shop lights together

if needed. Secure loose

cord slack.

CAUTION: Link a maximum of 4

shop lights together. Do not use

shop light outlets to power anything

other than these style shop lights.