Installation & Assembly

REV.111116
INSTALLATION GUIDE
www.maykke.com
INSTALLATION GUIDE
TOOLS AND MATERIALS NEEDED:
TOOLS AND MATERIALS NEEDED:
ADJUSTABLE WRENCH
Before beginning please read all installation instructions and observe all local safety and building
codes.
Inspect all products before installing. Contact Customer Service for any questions or concerns at 877.659.2858
or email: [e-mail].
Consult a professional if you are unfamiliar with faucet installation. We accept no liability for damages
to property or person during installation.
1. Unthread the lock nut if it is attached to the faucet body (some faucets will not require this piece). If
no lock nut is included or it is not attached please continue to step 2.
2. Attach the flexible water feed tubes to the tail-piece. Hot water is always on the left and cold water
is always on the right. (Continue to step 3 if the tubes are already connected)
3. Place the metal mounting washer (if included), or clip and rubber sealing gasket over the mounting
hole. If there is no top mounting washer or gasket continue to step 4.
4. If a decorative mounting plate is included place it over the mounting hole. If there is no decorative
plate, move on to step 5.
5. If faucet is included a mounting rod, remove the nut and screw the rod into the faucet. Continue to
step 6.
6. Feed water lines and tail piece through your countertop hole. Thread the mounting nut onto the
rod (if included) as well as threading the lock nut onto the tail piece from underneath the sink. Make
sure that the faucet is properly aligned and tighten the nut with your adjustable wrench.
7. Hand tighten the water lines to the main water supply, be careful not to cross the two during
installation. Using wrench turn and additional ¼ turn, being careful not to over tighten. Make sure
there are no kinks or knots in the tubes.
8. Install drain according to manufacturer’s instructions.
9. Once installation is complete, turn on the water supply, making sure that no water is leaking. Leave
water on for approximately one minute to insure installation is correct.