Specifications

CHECKING
FOUNTAIN HEATER WIRE
lf
a
faulty
heater wire is suspected it can
easily be checked
through
the connection
at
the
bottom
door hinge
behind the
grille.
1. Disconnect the unit f rom
power
source.
2. Remove the
grille.
3.
For
Side-By-Side models, remove the
White
and Red wire
connectors and
separate
the wires.
Make certain the fountain light is
turned
off.
Connect the
probes
of an ohmmeter
to
the wires and
perform
a
continuity
test. lf the
meter does not
show
continuity
it
can be assumed the wire
is
defective and must
be
replaced.
Remove four
(4)
inner
screws
to
remove
impeller assembly.
Pull
auger impeller
assembly
from
bin.
Drive ring will
disengage,
Unscrew impeller retainer.
Remove
pin
and auger will disengage.
Install
and reassemble in reverse
order
of
removal.
4.
5.
4.
1.
2.
INTERLOCK
SWITCH
The interlock
switch
following:
1.
Disconnect
the
source.
2.
Open the freezer
door and locate the
interlock
switch.
3. Use
a
putty
knife
to
pry
the switch
out
of the liner.
Cover
the knife
blade with
tape or with
a cloth to
prevent
scratching
the liner
surface.
is
checked by
the
unit f rom
power
3.
DISASSEMBLING ICE
6.
7.
8.
STORAGE BIN
Open
treezer
compartment door.
Lift
and
pull
ice
storage bin assembly
from the freezer
compartment and
empty any accumulated ice
cubes.
Place the
assembly on a smooth
surface.
Remove four
(4)
screws from the top
and
bottom
corners
of
the
ice storage
bin, releasing front.
5-24