Specifications

Remove
the wire
connections
and attach
the
meter
probes
to the
switch
terminations.
Depress the
switch
plunger.
The
meter will
show continuity
if it is
operative.
lf the switch
proves
operative
and the
problem
is still
present,
check
treezer
door alignment.
The door
may not
be
aligned and the
switch
plunger
may
not
be
activated.
AUGER
The
auger
motor is located
behind the ice
storage
bin.
The
yoke
fastened
to the
motor
engages the
drive ring
and turns
auger in
a
clockwise
direction. Both
the
yoke
and drive ring
are designed to
prevent
a loosening
of the
yoke
by
exerting
counter
pressure
while
in
operation.
The
auger motor
makes
one revolution
every three
seconds
and
makes
one
"dump"
every
one and half
seconds. To
determine
the free
movement
of the
auger
motor
open the
treezer
door
and
push
in
and hold
the
cabinet
switch in the
closed
position
while
pushing
in
the
ice
dispenser
activator.
AUGER MOTOR
The
auger motor is
easily be removed:
1. Disconnect
the
unit
from
power
source.
2. Remove
ice
storage
bin
from
the
treezer
compartment.
3, Remove
the
screws from
the auger
motor
mounting
bracket, releasing
the
auger motor
and
bracket.
4. Disconnect
the
auger
motor terminals
and remove
the motor
and
bracket.
5. Hold the
auger motor
armature
and
turn
the
yoke
clockwise releasing
yoke
from
motor
shaft.
6. Remove
screws that fasten
the
motor
to the mounting
bracket.
7.
Remove
the
auger motor
from
the unit.
8. Install
the replacement
in the reverse
order.
When
checking
auger motor,
remove
auger motor
from
unit and
attach
meter
probes
to the
auger motor
terminals.
The
meter
should
show continuity.
lf the
meter
does not
show
continuity,
the
motor
should
be
replaced.
5-25