Specifications

MI\YTAG
SECTION
6
ICE
MAKER
INSTALLATION
Top Mount Models
PREPARING
THE
FREEZER
1,
Unplug the refrigerator
power
cord
from
the wall
outlet.
2. Move
the refrigerator
out from
the wall
so
you
can work
at
the rear
of
the
cabinet.
3. On 15
and 17
cubic
foot
models,
remove
the right
end
of
the
wire shelf
by
pushing
it
up out
of
the two
shelf
brackets. Then
the
shelf will
slide
in
slightly to the left
and
the
shelf
can be
lowered
and removed
by
pulling
it to
the right.
4.
On 19,
21 and
23 cubic ft.
models,
remove
the
upper
wire
shelf by sliding
it to
the right,
then
lift
up on the left
end,
and
pull
out
of
right
side. Repeat
same motion
for the
bottom
wire
shelf.
Remove
the ice
storage
tray. With
a
phillips
screwdriver,
remove
the two
(2)
screws
on the treezer
divider
located
on the
bottom left
side
and
save
for reinsertion.
Gently move
the
left
end
of the top
plastic
shelf out
of
the left
cabinet wall
and carefully lift
assembly
out of
grooved
channel.
5.
6.
7.
8.
Remove the
existing
air duct by
removing
mounting
screw
and sliding
it to the left
out
of
the
channel. This
part
is no
longer required
when
using
the icemaker.
Using
a table
knife
or similar
instrument,
pry
out
plug
buttons
"E".
Unscrew
lcemaker
electrical
receptacle
cap
"F".
Pull
out the
plug
"D"
from the
fill tube
grommet.
With
a twisting
motion,
push
fill
tube
over the icemaker
fill tube
grommet
as
far
as it will
go,
approximately
1 inch.
6-1