Specifications

FILL TUBE
_--17@
A---
FILLTuBEGRoMMET
INSTALLING
ICE MAKER
1. On
15 and
17
cu.
ft.
models, use
the
small
air duct.
On
19
and
21 cu.
ft.
models, use
the medium
air
duct.
On
23 cu.
ft.
models, use
the
large air
duct.
2.
After
selection,
slide
the air
duct,
bottom
corner
first,
into the slot
on
the
left side
of the
rear air
tunnel.
Fasten
the air
duct
to the
rear freezer
wall
with one
Type
"A"
screw.
Plug the
ice
maker
power
plug
into
the
ice maker
electrical
receptacle
in the
left side
of the
cabinet.
Observe
the
pattern
of the
metal
pins.
They
must
be
positioned properly
to
fit the
ice
maker
receptacle.
Be sure
that the
plug
is
firmly seated
in receptacle.
Mount
the
ice
maker to
the side
wall
with 3
Type
"A"
screws
taking
care so
that
the fill
tube rests
in the
lill
tube
channel.
Start
with
the
back
screw
first,
then
the bottom screw,
and
finally
the top
front screw.
Do
not fully
tighten
any
screw
until all 3 screws
are
in
place.
Make
sure the
ice maker
sensor
arm
is down,
Again,
make sure
that
the
ice maker
power plug
is firmlY
seated
in receptacle.
3.
4.
4@q
6-2