Specifications

INSTALLING
WATER VALVE
AND CONNECTING TUBING
Working from the
rear:
1. For
the 22 and 24 cubic foot models,
remove the center
screw from the right
end
of
the black fiber
panel
that covers
the
machine compartment with
an
adjustable
wrench,
and
fold
back
the
etch marked
flap.
Save
the
screw
for
later reinstallation
as
this f lap is
required for
proper
and safe operation
of the refrigerator.
2. For
the 20 cubic
foot model,
follow
above
sequence for the
left side
of the
fiber
panel.
20
CU.
FT. MODEL
ATTACH
WATER
VALVE HERE
Locate
water valve
power plug
and
water
line
inside machine
compartment.
Remove
protective
cap
from water
line
and discard.
Slip the
plastic
nut
on
water
line.
Fit the
plastic
tubing into
the water
valve
as
far
as it will
go
and tighten the
compression
nut, finger tight.
Then
with a wrench,
tighten the nut
314"
ot
a turn.
Connect the
water valve
power
plug
to
the water valve.
Either wire
can
go
on
either terminal.
Attach
the water valve
to the inside leg
of
the
cabinet with two
(2)
type
"B"
screws
and tighten. Take
care not to
pinch
plastic
tubing
or let it
come
in
contact with
the
compressor
or
its
associated tubing.
Select the
proper
water
supply line.
For the
22 and 24
cubic foot models,
the
correct water
supply line is shown
in drawing.
For the 20
cubic toot
model,
the
opposite water supply
line
should be used
as shown in drawing,
Install the
hose nut, rubber
washer,
supply
line, and water
supply line
clamp
onto the water
valve. Do not
tighten the hose
nut
at
this
time.
Rotate water line.
Slide nut
and sleeve
on to
the
water
supply line.
Insert the
end of the
tubing
into the
compression
union
as
far
as it will
go.
Do not tighten,
this
will
be done
later.
3.
4.
5.
6.
7.
9.
10.
6-7