Specifications

NOTE: Some
ice makers
will have a
water
adjustment
knob. Pull off
the knob
to
remove
cover.
Be sure
to replace
knob
in
same setting
position.
WATER
PROBLEMS
Water
quality
can cause
ice makers to fail,
or
produce
unacceptable
cubes.
lf
mineral
content
or sand
is
a
problem,
the
screen in the
fill valve can restrict, or
a
particle
of sand
can keep the valve
from
seating
properly.
Results
will be small
crescents
(or
no ice) or flooding of
the ice
container if the
water valve
does
not
close.
Mineral content
can
also lime up the
mold,
causing
wicking
of
water over the
mold
and
poor
cube release. Silicone
is
applied
at
the
upper edges, around
fill cup and
stripper.
TEMPERATURE
PROBLEMS
Temperatures in the freezer
section
which
average
above
the normal 0o
*-5o
will
slow the
production
of
ice.
Complaints
of
inadequate
crescent
production
may be
corrected by simply setting
the freezer
to
a
colder temperature.
The thermostat
cycling
temperature in
this 1-revolution
ice maker is 17o
+
or
-3.
Obviously,
the
ice will be well f rozen
when these
temperatures are achieved but
cycling
time
will be
slowed
if the
freezer
temperature
is not
cold enough
to achieve
these mold temperatures easily.
NOTE: Only the thermostat,
mold, with
heater
&
wiring harness are
replaceable. Any
other
failure
(including
the motor) requires
replacement of the module assembly.
lf
you
are
replacing the mold assembly,
it comes with a new mold heater
installed.
External
. .
plastic parts
are
replaceabld.
A failed mold heater requires complete
replacement
of the mold and
mold heater
assembly.
TO
SERVICE
THERMOSTAT
lf the thermostat is diagnosed as
defective,
it
can be
removed
and
replaced
easily, Remove the control box
from the
mold by taking out two Phillips screws.
{screwsb
Pull
(Front
ol
Black Housing)
Pull the
housing
free
of the
mold,
and
you
will
see the
thermostat
on mold side.
also
Retaining
Glips
6-14