Specifications

7.
8.
Unsolder the
drier
from the
condenser
outlet
tube
and clean the outlet. Re-
move the drier from the
capillary tube
so the tubing assembly
can be
pulled
through the tube
entry opening.
Remove
the
sealer
and
grommet
from
the tubing
entrance at the
cabinet
rear. The sealer
and
grommet
must be
retained for replacement.
9. Working inside
the cabinet, remove
the following
items from
the lreezer
compartment.
a. The treezer
shelves
and
the
lreezer
basket.
b. lce tray rack,
or ice maker
if
so
equipped.
c. The
dispersing
shield from in front
of the lreezer
tan.
d. Freezer
evaporator
cover, and the
treezer
fan
ground
wire.
10.
Disconnect the radiant
heater
and de-
frost thermostat
leads.
1 1. Remove
the lreezer
evaporator
mounting
screws.
12.
Remove the two
styrofoam
blocks from
the top
corners
of the treezer
evapo-
rator.
These
blocks
must be reinstalled
the
same way
as they were
before re-
moval.
13.
Pull the
heat
exchanger through
the
tube
entry
opening. Pull
carefully
to
avoid
tearing the
sponge roll
on the
heat
exchanger.
14.
Remove
the
sponge roll from
the heat
exchanger.
Be careful
because this
roll must
be installed
on
the
replace-
ment
heat
exchanger.
IMPORTANT:
CAUTION MUST
BE TAKEN
TO PROTECT
THE
COPPER
-TO-
ALUMI-
NUM
WELDS,
WET RAGS
WRAPPED
AROUND
THE TUBING
AT THESE
POINTS
WILL
HELP PREVENT
DAMAGE.
IF
YOU
SECURE THE FREEZER
COIL AND
TUBING
TO PREVENT
MOVEMENT
OF
THESE
CONNECTIONS,
YOUR POSS/B/I-
ITY
OF DAMAGE
IS FAR
IESS BECAUSE
IT WILL
RELIEVE
THE
STRA/N
THAT
COULD
CRACK A WELD.
4-6