Specifications

10. Remove the
condenser
screws.
11.
Disconnect
the fan
motor
wire
leads
from the
compressor
terminals.
12. Remove
the
condenser
assembly from
the
compressor
mounting
rails
and
set
it
on
a workable
surface.
13.
Remove
the
screws
which
secure
the
fan
motor
shroud to
the
condenser.
14.
Transfer
all clips
to the
replacement
condenser
and
make
sure that
the
condenser
tubing
goes
through
the
rubber
sleeve
on
the fan
motor
shroud. Install
the
screws.
15.
Set the replacement
condenser
on the
compressor
mounting
rail
and install
the
screws.
16.
Clean
the
condenser
tubing
and
connect
the
discharge
line
to
the inner
tubing.
Connect
the
yoder
loop
to the
other
tube
of the
condenser.
17.
Cut
and install
the new
drier.
When
inserting
the
cap tube,
do not
allow
more
than
112 inch
of the
cap tube
to
penetrate
the
drier.
18.
Solder all the
joints.
Silver
solder
and
proper
flux
should
be used
on copper
to
steel
or steel to
steel
joints.
Flux
should
be
wiped
off the tubing
after
soldering.
19.
Visually
check the
joints
for leaks.
20.
Connect
the fan
motor
wire leads
to the
compressor
terminals.
21. Install
the
screws removed
in
Step 8.
22.
Lift the
refrigerator
to its
normal
upright
position.
23.
Evacuate,
recharge
and
leak test
system.
24.
Test run
the
refrigerator
to
make
sure
it is
operating
properly.
25.
Pinch
the
process
tube
and cut
off the
service
valve.
Solder
the
joint
and test
for
leaks.
REPLACING
CONDENSER
Side-By-Side
Models
IMPORTANT:
THE
FOLLOWING
PROCE-
DURE
REQUIRES
THE
PLACEMENT
OF
BLOCKS
OR BRACES
UNDER
THE
CABI-
NET IN
ORDER FOR
YOU
TO
REACH
CER.
TAIN
BOLTS
AND
SCREWS.
WE
WISH
TO
EMPHASIZE
THAT
YOU
SHOULD
MAKE
SURE
THE
BRACES
ARE
POSITIONED
FIRMLY
SO THAT
THERE
WILL
BE NO
DANGER
OF
THE
CABINET
FALLING
ON
YOUR
HANDS.
1. Disconnect
the
unit
f rom
power
source.
Disconnect
the
condenser
fan
ground
wire.
2.
Remove
the
machine
compartment
cover.
4-9