Specifications

3.
Place a
three inch block
under
front of
the cabinet.
Remove
the
unit
rail mounting screws.
Remove the rear mounting
screw
from
the
air divider baffle.
Remove the
3
inch
block
from the front
of
the
cabinet
and
place
it
under
the
rear
of
the
cabinet.
Remove the
screws and clamps
mounting
the
compressor base
pan.
Remove the
screw holding the
condenser
leg
on
the
right end.
Remove the relay
and overload from
the
compressor, but leave the wires
connected
to the
terminals.
Install service valve
as close as
possible
to
the tip of the
process
tube.
This
will allow
easy
pinch
off after
recharging the
system.
Connect a hose to the
service
valve
and slowly
release
the
pressure,
directing
the hose outdoors.
Leave the
valve open.
10.
Clean
the
discharge
tubing for a
distance
of about
3
inches
at
the
points
you
intend
to cut or unsolder. Cut or
unsolder the discharge line.
11. Remove the
screws
f rom the top of the
condenser. and
from the
back of
the
condenser.
12. Remove the
tubing clamps
from the top
and bottom of the fan shroud.
13. Remove the
condenser from
the
fan
shroud.
Set
the replacement
condenser
assembly in
place
and secure
it
with
the
screws
removed in
Step
11.
Silver solder
the
discharge line to its
respective condenser line.
lnstall the new drier as instructed
under
"Replacing
Drier".
Reassemble the high
side unit
in the
machine
compartment
in the reverse
order
of
the removal
procedure.
Evacuate,
leak test, and recharge the
system as instructed under
"Evacuating
and Recharging".
Reinstall the
ground
wires where
removed.
Reinstall the
machine compartment
cover exactly as
it was
before
removal
so
that
proper
air flow is maintained
across the compressor
and defrost
pan.
Test run the refrigerator to make sure
it is
operating
properly.
the
two
5.
14.
15.
16,
17.
18.
19.
20.
21.
L
o.
7.
8.
4-10