Specifications

1.
2.
Disconnect
the
unit
from
the
power
source.
Remove the freezer
fan
dispersing
shield.
Remove the
upper evaporator cover.
You
will have to drive the
center
pins
out of the rivets to remove them.
Disconnect
the
fan
motor leads from
the
cabinet
wiring.
4. Attach
a
110
volt test cord to the
fan
leads
-
plug
the test
cord into the
electrical
outlet. lf the fan fails to
operate, the motor
or its leads is
defective.
5.
The
replacement motor
will
be
attached to the bracket
in the same
manner
as the original.
FAN
BLADE ALIGNMENT
ln the
event
that the
treezer fan
blade is
removed
or loosened, reposition
it
on the
shaft
by
pushing
it
on until the
stop resets
against the end of the
shaft.
DTVIDER
CHANNEL
HEATER
Top Mount Models
Only
CHECKING
THE
DIVIDER
CHANNEL
HEATER
WIRE
The
divider channel
heater
wire can be
checked
without
disassembling the
unit.
1. Disconnect
the
unit from the
power
source.
2.
Make a continuity
check
of the switch
and heater
across terminals
2
-
3.
and
3
-
1.
REPLACING
DIVIDER
HEATER WIRE
The
foil mounted
divider
channel heater
wire is
stuck to
the rear
surface of the
divider face
plate.
The
wire is replaced
by
peeling
the
old
one off the
divider channel
and
sticking the
replacement
one on. To
replace
the wire
proceed
as follows.
1.
Disconnect
the
unit
from
power
source.
2.
Remove
the facade
and the
divider
channel
and disconnect the
heater
leads
and
ground
wire.
3. Remove
the
old heater
wire
and
replace.
4.
Reconnect
the
heater
wire and
reassemble
those
parts previously
removed.
4-36