Specifications

REFRIGERATED
MEAT
KEEPER
The
meat
keeper has a
shutter control to
adjust the
amount of air
admitted into the
pan
interior. NOTE:
Make sure
meat
keeper
is installed in the
refrigerator
so
the
arm
on
meat keeper
can
come in
contact with
baffle.
CHECKING
OPERATION
Most
problems
concerning the
meat
keeper
will result from
improper
operation
of the
air shutter. However,
don't
overlook
the
possibility
that frozen
packages
may
have
blocked the
air
inlet
from the freezer
compartment.
REPLACING
THE
REFRIGERATED
MEAT
KEEPER
COVER
The
plastic
cover
of
the
meat keeper
can
withstand
a
great
deal
of stress but if it
becomes
necessary
to replace the
part,
proceed
as
follows:
Pull
the
pan
out until it
stops, lift it
slightly
and at the same time
pull
the
pan
completely
out.
Lift and remove
the
shelf assembly
out
of the
refrigerator.
Set
the
shelf
upside-down
on a work
surface.
Insert
a straight screwdriver
under
the front
corner of
drawer and
remove
the
plastic
rivets.
4. Lift the front
of the
drawer and
pull
it
out of the
shelf frame.
5. The drawer
is installed
in the reverse
order of removal.
NOTE: The
meat keeper
drawer can
be
dismantled
by
removing
plastic pins
from
the
side of
the
drawer
and unsnap
at the
back of the
drawer. Now
you
have access
to the
control
bar.
REPLACING
FRIGID
MEAT
CONTROL
To remove
the
sliding baffle
in the frigid
meat control:
1. Lift
off the
meat
pan
housing
assembly.
2. Remove
the air tunnel
from the freezer
back by removing
one rivet
at the
bottom.
3, Lift the
styrofoam
insulation to
get
at
the sliding
baffle.
4.
Slide the baffle
out of the tunnel.
1.
2.
3.
5-3