Specifications

FREEZER COLD
CONTROL
Side-By-Side Models
The
freezer control
is a mechanical baffle
that
can be
adjusted to
regulate the
amount of chilled air
that is
allow
to enter
the fresh food compartment.
This control is also located at the back and
top
of
the fresh food
compartment.
lt is
held in
place
by
two
(2)
screws
(lower
front
and and upper
rear).
MOUNTING HARDWARE
NYLON SNAP
NUTS
Snap nuts are
used
in
places
where
screw must mount into
the liner.
To remove
a snap
nut,
pry
it loose
with
small screwdriver
or a
putty
knife.
Install
a snap nut by
pressing
the nut into
the
opening until
it snaps into
place.
PLASTIC
RIVETS
Drive
pin
type
plastic
rivets
are used to
mount
some of the
components inside the
food and treezer
compartments of these
models.
The
procedure
for removing
these
rivets
is shown. To install
one of
these rivets,
press
it into
place
and drive
the center
pin
in until it is flush
with the
rivet
shoulder.
TWIST NUTS
This type of nut is
used
to mount
parts
in
the refrigerator
and
treezer
compartment.
They are installed
before the cabinet is
foam insulated
so if
one becomes
damaged it must
be
replaced
with a snap
nut.
DRAIN TUBES
Top Mount
Models
During the
defrost cycle, water from the
treezer
coil collects
in the drip tray,
and
runs through
the hole in the
drip tray
and
along
the
upper
surface of the fresh food
compartment
ceiling. This water
is
channeled
to
run
in two
different
directions
down the
back wall of the
refrigerator.
This
prevents
it from running
directly to the cantilever
shell support
as
it
flows to the
drain tube.
i':
ll
il
l!
li
{i
:l;
tl
tr
t,
/:\
*$
,$
i$,
I
i
(
/*
/
DRAIN
TUBE
Side-By-Side Models
Side-by-side
models have
a drain tube
that
attaches to the
drain
trough,
passes
through
a
grommet
in the lreezer liner
and
extends out the cabinet
bottom.
5-6