Specifications

CABINET
DOOR^S
AND
ASSOCIATED
PARTS
PAINT
TOUCH.UP
Painted
areas of the
cabinet
or doors that
become
scratched
or marred
can
be
touched
up with
enamel.
When
manufactured
a
high
solids
polyester
is
used.
WARNING:
NEVER
USE LACOUER
ANY
PLACE
ON THE CABINET
WHERE
IT WILL
CONTACT THE
DOOR
GASKET. LACQUER
WILL
DETERIORATE
THE VINYL
MATERIAL
IN THE
GASKET.
DOOR LINER
Top Mount
Models
REMOVING
AND
REPLACING
DOOR
LINER
The
polystyrene
inner
door liner
and the
door
gasket
are mounted
to the
outer
panel
by screws
placed
around the
door
flange.
The inner
door liner
could be
replaced
without
removing
the
door from
the
cabinet.
lf it is
necessary
to remove
the
door liner,
proceed
as follows:
1. Turn
the
control to the
off
position.
2.
Open the freezer
door
and remove
the
screws
and metal
bracket from
around
the
door flange,
Remove
the door
liner
and
transfer
the
gasket
and
metal
bracket to
the
replaeement
liner.
Make
sure that lip
"A"
of the
door
gasket
will
be
sandwiched
between
the inner
panel
and the retainer
strip.
Position
the replacement
door liner
and loosely
install
all the
screws
around
the
door flange.
5.
Close and
open the
door several
times
and check the
gasket
for
proper
seal.
6.
Carefully
open the
door
by
pulling
on
the
middle
section
of the
door
panel.
NOTE: DO NOT
PULL
THE DOOR
BY THE
HANDLE
OR THE PANEL
WILL
SHIFT OUT
OF ALIGNMENT.
Tighten
all corner
screws
snug tight.
Close
and
open the
door several
times.
Recheck
the
door
gasket
for
proper
seal. lf it is
good,
tighten
the
rest
of the
screws.
Avoid
overtightening
the
screws.
Tighten
the
screws
until they
are
just
snug, then
turn them
clockwise
another
one-half
turn.
NOTE:
DO
NOT ATTEMPT
TO
TWIST
THE
DOOR
PANEL
AFTER
ALL
THE
SCREWS
HAVE BEEN
TIGHTENED.
9. Transfer
the
shelf trim
to
the
replacement
liner.
7.
L
3.
4.
5-9