Specifications

DOOR
LINER
Side-By-Side
Models
The inner door liner and the
door
gasket
are
mounted to the
outer door
panel
by
screws
placed
approximately every four
inches
around
the
door
flange.
Although
the
procedure
for
reassembling these
items
seems obvious, the following facts
should be
kept in
mind:
1.
Always lay the
door on a flat, well
padded
surface
during reassembly.
2. Position the
gasket
around the inner
panel
so that it will
be sandwiched
between the
door
liner
and the metal
bracket.
3. Tighten
all
inner
panel
mounting
screws until they
are
just
snug.
4. Don't
tighten the inner
panel
mounting
screws unevenly,
or attempt to twist
the door
after
the
screws have
been
tightened.
Such action may
permanently
damage the inner
panel.
5.
Always
align the
door as
instructed
under
"Cabinet
Door Alignment",
whenever
any inner
panel
mounting
screws have
been
removed.
DOOR PANEL
Top Mount Models
REMOVING
AND
REPLACING
DOOR PANEL
UPPER
DOOR
1. Turn
cold control to
off
position.
2. Remove
door handle
and trim.
3. Use a soft lead
pencil
to trace
around
the upper hinge.
This will
aid in
replacing the hinge.
4. Remove
the upper hinge and
place
on
top of
unit
with
newspaper
or cloth
underneath
to
prevent
scratching. The
door will
remain held in
place
by the
magnetic
aasket.
Do not misplace
the
plastic
spacers.
5. Carefully open the
door and lift it
up
and off the
center hinge
pin.
Care
should be taken not to
misplace the
center hinge
pin
spacers. Place door
on flat work
surface.
6. Transfer handle,
trim, insulation,
plug
button,
bushings,
gasket
and
liner
to
replacement
panel.
7.
Position
door
onto center
hinge
pin
and caref
ully close
door.
The
magnetic
gasket
will
hold the door in
place.
8.
Install
the top hinge
using the tracing
to help
align the hinge. Make
sure the
plastic
spacers are installed.
L Open and
close
the
door
several
times
and
tighten
the liner
mounting screws.
Do not twist
the door
after
the
screws
have
been tightened.
LOWER DOOR
Remove
upper
door.
Remove
center hinge
pin.
Make
sure
not to misplace
the
plastic
spacers.
Carefully open the
door and lift it
up
and off the lower
hinge. Place
door on
flat work surface.
NOTE: lf
unit has
an ice
and
water
fountain,
pull
wires
and
water
line through
the hinge.
Transfer
handle,
trim, insulation,
plug
button, bushings,
gasket
and
liner
to
replacement
panel.Do
not tighten
the
liner mounting
screws.
Position
door
onto bottom hinge,
position
center hinge
into
bushing.
Close door.
Install the
upper door
and
hinge.
Open
and close the
doors and tighten
the liner
mounting
screws.
1.
2.
3.
4.
5.
o.
7.
5-10