Specifications

REVERSING DOORS
Top
Mount models, with the exception of
models
having
ice
or
water through the
door, are manufactured with
reversible
opening
doors.
The instructions for
this
are
covered
in
SECTION
2
-
INSTALLA-
TION.
DOOR
REMOVAL
Door
removal is covered in
SECTION
2
-
INSTALLATION.
Care should
always
be
taken when removing
doors on models
having
an
ice
or
water fountain.
TOP HINGE
AND
DOOR
CLOSER
Side-By-Side Models
To
remove the
upper
hingd from
either
cabinet
door,
proceed
as follows:
1. Trace
around the upper hinge
and
remove
the mounting
screws.
The
hinge
on the lreezer door is
under a
small
amount of
tension
and will
push
toward
the center of the cabinet when
the mounting
screws are released,
2. Pull
the hinge straight
out until it
clears the
door.
When installing
the
top
hinge,
install
it as shown. You will
have
to
pull
it
toward the
outside edge
of
the
cabinet to line up the mounting
screws.
DOOR
CLOSER
Side-By-Side Models
There
are
no
specif ic door
closer
adjustments with which
you
can improve
the door
closer operation.
lf
it seems to
be
operating
improperly,
you
should make
sure
the
cabinet
is
level and that the
doors
are
properly
aligned. The
cabinet must be
level
or tilted back
slightly, so
the
door
closer doesn't have to
pull
the
door uphill
when
closing it,
lf
leveling
and
door alignment
adjustments
don't
help,
and
you
are sure
the doors
are
properly
spaced out
from
the
cabinet so
the
gaskets
aren't
binding,
the door closer is
probably
defective and
must
be
replaced.
To replace the
door closer,
remove
the top
hinge, inner
door
panel,
and the two door
closer mounting screws.
As
you
install the replacement
door
closer, make
sure
that the nylon
cam
is
positioned
as shown.
lf the
cam is turned
180
degrees,
the
door closer action will
be
reversed.
5-11