Specifications

REPLACING
TUBING
FROM THE WATER
VALVE
TO THE ICE
MAKER
1.
Shut
off
the electrical supply
to the
unit.
2. Remove
the
machine
compartment
cover
from
the rear
of
the unit.
3. Remove
the water
valve mounting
screw and
disconnect the ice
maker
supply
tubing from the water
valve.
Drain the
water into
a container.
4. Remove the wire cover
from the
cabinet back.
5. Remove the tubing clamps
from the
cabinet back.
6. Remove
the
clamp
which fastens the
supply
tubing to the fill
grommet
supplying the ice maker.
7. lnstall the
replacement
tubing
in the
reverse
order of
removal
and check
all connections
for
leaks.
NOTE: When installing the
supply
tubing
care
should be
taken not to crimp, kink or
bend the tubing so that a restriction
is
formed.
REPLACING TUBING
FROM
WATER
VALVE
TO WATER
RESERVOIR
1.
Shut off the electrical supply
to the
unit.
2. Remove the machine compartment
cover from the rear of the unit.
3.
Remove
the water valve mounting
screw and disconnect the
compression nut from the water valve
supplying the
chilled
water fountain.
4. Remove the
crisper shelf.
5.
From the
back of the refrigerator,
disconnect the compression nut from
the
bottom
reservoir
connection.
Drain
the water
into a container.
6. Pull the comoression nut off of the
supply
tubing
and
pull
the
supply
tubing f
rom
the
back
of the unit
through the
bottom.
(To
pull
new
tubing,
tie
to the old and
pull
with old
tubing.)
7. Install the replacement tubing in the
reverse order of removal.
8.
Turn
on
the
electrical and
water
supply and activate the chilled water
dispenser. Draw six or seven
glasses
of water to
remove
any trapped air in
the
system. Check all
fittings for leaks.
REPLACING THE TUBING FROM THE
RESERVOIR
TO
THE FOUNTAIN
The
supply
tubing from
the
reservoir to the
fountain is
composed of
two
sections and
extends
from:
1.
Reservoir to a connection
at
the
bottom of
the
cabinet behind
the right
side
of
the
grille.
2. Then, from the connection behing the
grille
to the fountain.
5-16