Specifications

4.
5.
6.
7.
Pull the escutcheon
towards
the door
handle to snap,
or disengage
from
fasteners.
On
Side-By-Side
models,
pull
escutcheon away from
door handle.
Remove wire
cover by removing
two
screws.
You now have
access to
the selector,
light
and lock
switches.
Remove
screw from
side
of
fountain
that
will
allow removal
of well
trim.
Carefully
pull
the trim
out
of the
fountain
so
you
do not damage
it.
Now
remove
all the
screws from
around the
fountain
assembly
and
carefully
pull
the
assembly
out of the
refrigerator
door.
You now
have full
access to
solenoid,
dispenser
mechanism
and remaining
switch.
To
replace
the
entire
assembly
disconnect
water
and electrical
lines.
NOTE:
To
check trap
door for ice
chute,
activate
solenoid
by using
switch on
dispenser.
NOTE:
When
reinstalling
fountain
assembly,
make
sure
water tube
is
positioned
so that
the insulation
is
between the
tubing
and the inside
panel.
REPLACING
ICE AND
WATER
ACTUATOR
swrTcH
When
the ice
and water
actuator
pad
is
depressed,
a
switch located
behind
the
pad
is closed
completing
a
circuit through
a
blue
wire connected
at the
selector
switch,
through the
actuator switch
and
then
passing
through
a
gray
wire
to the
child-proof
switch.
To Remove:
1.
Remove
fountain
assembly from
front
of refrigerator.
2.
The switch
is located
on the back
of
the
assembly
as shown
on next
page.
Remove
one
(1)
screw
to remove
switch
and
switch
bracket.
8.
5-21