Operating instructions

ManualsBrandsMaytag ManualsDishwasherBUILT-IN ELECTRIC MICROWAVE OVEN

30” BUILT-IN

MICROWAVE OVEN

COMBINATION

IMPORTANT

INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER.

HOMEOWNER: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

ave

Ovens,

Compactors, Room Air Conditioners, Dehumidifiers,

Automatic

Washers, Clothes Dryers, Freezers, Refrigerator-freezers, Ice Makers,Dishwasl

Summary of content (8 pages)

PAGE 1
30” BUILT-IN MICROWAVE OVEN COMBINATION IMPORTANT INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE HOMEOWNER. HOMEOWNER: RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PAGE 2
PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY Before you begin II Do not attempt to operate this oven with the door open since open-door operation can result in harmful exposure to microwave energy. It is important not to defeat or tamper with the safety interlocks. Read these instructions completely and carefully. If followed, they will simplify the installation job.
PAGE 3
B. Check microwave for damage Remove all packing material from the oven cavity. When unpacking the unit, check for damage such as misaligned door, damaged gaskets around the door, or dents inside the oven or on the exterior. If there is any damage, please do not operate the unit until it has been checked by an authorized Whirlpool trained service technician. C. Electrical requirements IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE LOCAL ELECTRICAL INSPECTOR’S USE A.
PAGE 4
Begin the installation Remove racks and all other contents before removing appliance. - from oven A. Remove shipping skid VIEW A 2. Put a nail (932” or smaller) or equivalent in the hole in each of the hinges. Close the oven door until the pins touch the oven front. See View 13. 3. The oven door can now be lifted off. 4. Reinstall oven door the same as on non-self cleaning models. (See page 5) 5.
PAGE 5
Removing the oven door may make it easier to clean the oven. To remove the door, first open it to the first stop (about 4 inches or 10 cm). Take hold of both sides of the door near the top; then lift it at the same angle it is in. TO REMOVE OVEN DOOR (NON-SELF-CLEANING MODELS) With the door off, you will notice how the ends of hinges slide into slots at the bottom corners of the door. To put the door back on, fit both corners of the door over the ends of the hinges.
PAGE 6
0 A Electrical ground is required on this appliance. This appliance is equipped with copper lead wires. If connection is made to aluminum house wiring, use only special connectors which are approved for joining copper and aluminum wires in accordance with the National Electrical Code and local codes and ordinances. This appliance is manufactured with a white neutral power supply wire and a frame connected green ground wire twisted together.
PAGE 7
E Before you call for service . . . SJ See the Use and Care Guide for trouble-shooting checklist. If you must call for service. . . You will need the appliance model and serial number Find the serial plate on the front frame of the microwave oven behind the microwave oven door. Check for blown fuses or tripped circuit breaker.
PAGE 8
Whirlnool HOME -% APPLIANCES Making your world a little easier In the event your the appliance or telephone dlrectorv name and number (800) 253~1301. Dial just as you nearest Whirlpool this same number in your Use and Learn the WHIRLPOOL WHIRLPOOL appliance should need sewce, call the dealer from whom you purchased service company. He is in the Yellow Pages of your a WHIRLPOOL franchised TECH-CARE’9 You can also obtain his heted under “Appliances-Household-Maior-Service and Repair.” by dialing.