Installation guide

IO,
11,
12,
Connect the dryer power cord to 120 volt
AC outlet for gas models. 240 volt outlet
for electric models.
Make appropriate external ground
connection. See DETAILED installation
instructions for
ELECTRICAL
REQUiRE-
MENTS AND
GROUNDING
(pages 6-7).
Slide washer a))the way back into stand.
Tabs on stand legs are to slide into the
washer front panel. Adjust the washer
front legs. Leve) washer on stand. Lock
leveling legs in position using lock nuts.
it is very iMPORTANT
that the washer sits in
the stand
properly. Unit
must be solid
and level.
Check unit to
finish leveling.
Be sure to lock
ALL leveling
leg lock nuts.
,, Remove tub block ring from washer tub
opening.
,, Verify that all instruction packages have
been removed from washer tub and
dryer drum.
See installation Checklists for washer
and dryer.
DRYER (NSTALLAT(ON CHECK MST
Dryer is plugged into electrical outlet and
is properly grounded.
Exhaust duct work is hooked up and
joints taped.
Plastic flexible duct is NOT used.
Use rigid or stiff-walled flexible metal vent
material.
Dryer is level with all legs firmly on the
floor, with the lock nuts tightened.
Vinyl feet have been installed.
Gas Models - gas is turned on, there are
no gas leaks.
Dryer runs, heats, shuts off.
Demonstrate use to consumer.
WASHER (NSTALLAT(ON CHECK L(ST
Tub block, parts package and instruc-
tions have been removed from the tub.
Water has been turned on. Checked
for leaks at faucets and water valve
connections.
Drain hose is properly located into
drain facility and is not damaged.
Washer has been leveled with legs
firmly on the floor. The front leveling
legs' locking nuts have been tightened.
Fill washer, checking for the correct
water temperature.
After the washer has filled, let the
washer agitate.
Spin the water out.
Demonstrate washer usage to consumer.
Be sure to leave these instructions and
the User's Guide with the owner.
WASHER (NSTALLAT(ON ACCESSORY K(TS
Part No°
12001875
12001585
12001586
12001599
211692
204986
Description
Grounding Kit
Drain Hose Extension
Siphon Break
Small Diameter Standpipe
Drain Hose
Non-Slip Disc
Carpet installation Disc
Application
Contains ground wire, clamp, ground screw and washer.
Extends drain hose for drain facilities higher
than 1.2 m (4 ft.).
Used when an air-tight connection exists between
drain hose and drain facility. Floor drain facilities.
Used when standpipe diameter is too small to
receive end of drain hose.
For painted/sloped floors.
For carpeted floors.
12 printed in U.S.A.